Home > Power Inverters > Magnum Energy >

Midnite Solar - MNE175STM-L - 240 Magnum E-Panel 175A Breaker 120/240VAC Split
Midnite Solar - MNE175STM-L - 240 Magnum E-Panel 175A Breaker  120/240VAC Split

Our Price: $695.00

Quantity in Stock: Call to Order
Product Code: MEMNE175STML240

Product Features Technical Specs Contact Us
White aluminum configured for 120/240 VAC in and out for MS4448. This inverter features a true 120/240 input and output. This means your no longer need two inverters to fully utilize your 240 VAC generator. It also provides 120/240 VAC operation without the need for transformers or a second inverter.

The E-Panel also has a separate PV input terminal block that provides a place to tie in your PV input breaker, PV input and a PV lightning arrestor. There is also a terminal bus bar for the battery plus as well as as battery minus. No more need for ring terminals for these hook ups.

One of the best features of the MidNite E-Panel is the ability to complete much of the installation wiring right in the shop while the E-Panel is on the bench. You can connect your PV control breakers, lightning arrestors, battery status monitor, DC load circuits and AC load circuits prior to heading out the job site. This greatly reduces the chance of forgetting something a a location that is usually far away from the nearest store.

The inverter sports a 60 amp power factor corrected charger running at 80 kHz. This insures that virtually any generator made will be able to connect and charge from this (and all other) Magnum inverters/chargers. The 40 kHz invert swicthing speed and sampling rate is two times faster than the other popular off-grid inverter.

The MidNite Solar E-Panel comes standard with the basic over-current protection and disconnects required to install your renewable energy system. It can also expand to grow as your needs arise.

Inverter installation has just gone from hours to minutes with MidNite Solar's E-Panel. These disconnect boxes can easily be stacked horizontally or vertically to save space.

Small size compared to existing disconnect and over current solution
Pre-wired to save time, money and complexity
All field wiring connections clearly labeled
Easily expands to accommodate additional inverters
Six slots for din rail breakers, PV, Wind, Hydro, AC distribution
Bus bars for Battery Plus, Battery Minus and ground
ETL listed to UL and Canadian standards

All E-Panels now come with a side plate that accommodates up to three panel mount breakers like the MNEDC80.

DC Inverter battery breaker
Internal inverter cables
Pre-wired 50 amp 240 VAC rated Inverter AC bypass switch
Pre-wired 50 amp 240 VAC rated AC Input disconnect
500 amp shunt
AC terminal blocks

Heavy duty 250 amp AC distribution block
DC positive and and DC negative bus bars
Terminal bus bars for 120/240 VAC input and output
Din rails with 6 slots
DC wiring cover
Top shield
Remote mounting hardware
Wall mounting brackets
Charge control bracket (CCB)
Lots of hardware and grommets
Lots of hardware and grommets
Cut outs for two GFCI outlets

Share your knowledge of this product. Be the first to write a review »